Advertisement
TG7100_7120E(e)_QG.fm Page 4 Wednesday, July 5, 2006 10:18 AM
5 Frequently asked questions
Question
What kind of power outlet
should I connect the AC
adaptor to?
Why is w flashing?
Why is the handset display
blank?
What should I do when the
handset does not turn on?
How long should I charge new
batteries?
How long is the battery
operating time?
Can I keep the handset on the
base unit or charger when I
am not using it?
Cause & solution
Connect the AC adaptor to a 220–240 V outlet.
L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antennas
and mobile phones.
L The handset is not registered to the base unit. Register it.
{j/OK} i "Handset Setup" i {>} i
"Registration" i {>} i "Register H.set" i
{>} i Press and hold {x} on the base unit for about 3
seconds, until the registration tone sounds. i Wait until
"Enter Base PIN" is displayed. i Enter the base unit
PIN (default: "0000"). i {j/OK}
The handset is not turned on. To turn the power on, press
{ih} for about 1 second.
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
Charge the batteries for about 7 hours.
When you are using fully-charged Ni-MH batteries
(included batteries);
In continuous use: 17 hours max.
In continuous standby mode: 180 hours max.
L It is normal for batteries not to reach full capacity at the
initial charge. Maximum battery performance is reached
after a few complete cycles of charge/discharge (use).
L Actual battery performance depends on a combination of
how often the handset is in use and how often it is not in
use (standby).
L Even after the handset is fully charged, the handset can
be left on the base unit or charger without any ill effect on
the batteries.
–
–
4
Advertisement
