Reflectors; Fork Mount Reflector Bracket Assembly; Front Reflector Mount With Caliper Brake Assembly - PACIFIC CYCLE Part Instruction Manual

Reflectors

Your bicycle is supplied with one front (white), one rear (red), two wheel (white), and four pedal (orange)
reflectors. (Please Note: Sidewalk bikes, 12" and under, may not have reflectors.) These are an important safety and legal
requirement, and should remain securely fitted and in good, clean condition at all times. Periodically, inspect all reflectors,
brackets and mounting hardware for signs of wear or damage. Replace immediately if damage is found. Some bicycles will
require you to install your reflectors onto your bicycle. Please refer to the following section for instructions on all the types of
bicycle reflectors.

Fork Mount Reflector Bracket Assembly

First insert one washer onto the hex bolt and insert hex bolt through the reflector
bracket and then through the fork. Next, insert a second washer onto the bolt and
thread a hex nut onto the bolt behind the fork. Tighten bolts until snug, making sure
the reflector is in an upright position. See diagram at the right.

Front Reflector Mount with Caliper Brake Assembly

First remove the hex nut from the back of the fork and pull the brake from the fork.
Insert a spacer, washer and the reflector bracket on to the caliper bolt. Insert the
caliper bolt back into the fork and secure firmly with a concave spacer, washer and
the hex nut. Finally, adjust the reflector such that it is in an upright position. See dia-
gram at the right.
12