Craftsman 247.889702 Operator's Manual page 23

4, Carefully pivot the snow thrower upand forward so that i trests o n
the auger housing.
5, Remove the frame c over from the underside ofthe snow thrower
byremoving the self-tapping screws which s ecure it,See Figure
29,
6, Remove the belt a sfollows, Refer toFigure 30,
a, Loosen and remove the shoulder screw w hich a cts a sabelt
keeper,
b, Unhook the support bracket spring f rom the frame.
7, Remove the belt f rom around the auger pulley, and slip the belt
between thesupport bracket and the auger pulley. See Figure 31,
8, Reassemble auger belt b yfollowing these i nstructions inopposite
order and manner ofremoval.
9, Perform t he Auger Control test o utlined inthe Assembly section
ofthis manual,
/
NOTE:Do NOTforgetto reinstallthe shoulderscrewand reconnect
the springto the frame after installinga replacementaugerbelt,
Figure29
f
Figure30
f
23
Figure31