Mowing Tips - Craftsman 917.28890 Operator's Manual

25.0 hp, 48" mower electric start automatic transmission
Table of Contents

Advertisement

Available languages

Available languages

3.
Allow
one minute
for transmission
to
warm
up. This can be done during
the
engine
warm
up period.
• The attachments
can be used during
the engine
warm-up
period
after the
transmission
has been warmed
up and
may require
the choke
control
be pulled
out slightly.
NOTE:
If at a high altitude
(above
3000
feet) or in cold temperatures
(below
32 F)
the carburetor
fuel mixture
may need to
be adjusted
for best engine
performance
(see "TO ADJUST
CARBURETOR"
in the
Service
and Adjustments
section
of this
manual).
_RGE
TRANSMISSION
CAUTION:
Never engage or dis-
engage freewheel
lever while the engine
is running.
To ensure proper operation and per-
formance,
it is recommended
that the
transmission
be purged before operating
tractor for the first time. This procedure will
remove any trapped air inside the trans-
mission which may have developed
during
shipping of your tractor.
IMPORTANT:
Should your transmission
require removal for service or replace-
ment, it should be purged after reinstall-
ation before operating the tractor.
1. Place tractor safely on a level surface
- that is clear of objects and open - with
engine off and parking brake set.
2. Disengage transmission
by placing
freewheel
control in disengaged
posi-
tion (See "TO TRANSPORT"
in this
section of manual).
3. Sitting in the tractor seat, start engine.
After the engine is running, move
throttle control to slow position. Disen-
gage parking brake.
AUTION:
At any time, during step 4,
there may be movement of the drive wheels.
4. Depress forward drive pedal to full
forward position and hold for five (5)
seconds and release pedal. Depress
reverse drive pedal to full reverse posi-
tion and hold for five (5) seconds and
release pedal. Repeat this procedure
three (3) times.
5. Shutoff engine and set parking brake.
6. Engage transmission
by placing free-
wheel control in engaged position (See
"TO TRANSPORT"
in this section of
manual).
7. Sitting in the tractor
seat, start engine.
After the engine is running, move
throttle control to half (1/2) speed.
Disengage parking brake.
15
8. Drive tractor forward for approximately
five feet then backwards for five feet.
Repeat this driving procedure three
times.
Your transmission
is now purged and now
ready for normal operation.
MOWING TIPS
• Tire chains cannot be used when the
mower housing is attached to tractor.
• Mower should be properly leveled for
best mowing performance.
See "TO
LEVEL MOWER HOUSING"
in the
Service and Adjustments
section of this
manual.
• The left hand side of mower should be
used for trimming.
• Drive so that clippings are discharged
onto the area that has already been
cut. Have the cut area to the right of
the tractor.
This will result in a more
even distribution
of clippings and more
uniform cutting.
• When mowing large areas, start by
turning to the right so that clippings will
discharge
away from shrubs, fences,
driveways,
etc. After one or two rounds,
mow in the opposite direction making
left hand turns until finished.
f
f
,
.J
• If grass
is extremely
tall, it should
be
mowed
twice
to reduce
load and pos-
sible fire hazard
from dried clippings.
Make first cut relatively
high; the second
to the desired
height.
• Do not mow grass
when
it is wet.
Wet grass
will plug mower
and leave
undesirable
clumps.
Allow
grass to dry
before
mowing.
• Always
operate
engine
at full throttle
when
mowing
to assure
better
mowing
performance
and proper
discharge
of
material.
Regulate
ground
speed
by
selecting
a low enough
speed
to give
the mower
cutting
performance
as well
as the quality
of cut desired.
• When
operating
attachments,
select
a
ground
speed
that will suit the terrain
and give
best performance
of the at-
tachment
being used.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents