Mowing Tips - Craftsman 917.377592 Owner's Manual

MOWINGTIPS
o Undercertainconditions, s uchas very
tall grass,it maybenecessary to raise
the heightof cut to reduce pushingeffort
andto keepfromoverloading theengine
andleavingclumpsof grassclippings It
mayalsobe necessary to reduce
groundspeed and/orrunthe lawn
mowerovertheareaa second time
o Forextremely heavycutting,reducethe
widthof cutby overlapping previously
cutpathandmowslowly
. For better grass bagging and most
cutting conditions, the engine speed
should be set in the fast position.
° When using a rear discharge lawn
mower in moist, heavy grass, clumps of
cut grass may not enter the grass
catcher Reduce ground speed (push-
ing speed) and/or run the lawn mower
over the area a second time
,, If a trail of clippings is left on the right
side of a rear discharge mower, mow in
a clockwise direction with a small
overlap to collect the clippings on the
next pass.
• Pores in cloth grass catchers can
become filled with dirt and dust with use
and catchers will collect less grass. To
prevent this, regularly hose catcher off
with water and let dry before using
,, Keep top of engine around starter clear
and clean of grass clippings and chaff_
This will help engine air flow and extend
engine life
MULCHING MOWING TIPS
IMPORTANT: For best perfon'nance, keep
mower housing free of built-up grass and
trash See "Cleaning" in Maintenance section
of this manual
o The special mulching blade will recur the
grass clippings many times and reduce
them in size so that as they fall onto the
lawn they will disperse into the grass and
not be noticed Also, the mulched grass will
biodegrade quickly to provide nutrients for
the lawn Always mulch with your highest
engine (blade) speed as this will provide the
best recurring action of the blades
° Avoid cutting your lawn when it is wet. Wet
grass tends to form clumps and interferes
with the mulching action The best time to
mow your lawn is the early afternoon At
this time the grass has dried and the newly
cut area will not be exposed to the direct
sun_
• For best results, adjust the lawn mower
cutting height so that the lawn mower cuts
oft only the top one4hird of the grass blades
If the lawn is overgrown it will be necessary
to raise the height of cut to reduce pushing
effort and to keep from overloading the
engine and leaving clumps of mulched
grass. For extremely heaw mulching,
reduce your width of cut by overlapping
previously cut path and mow slowly.
o Certain types of grass and grass conditions
may require that an area be mulched a
second time to completely hide the
clippings When doing a second cut, mow
across or perpendicular to the first cut path.
. Change your cutting pattern from week to
week. Mow north to south one week then
change to east to west the next week. This
wilt help prevent matting and graining of the
lawn,
Max 1/3
9