Table of Contents
Advertisement
AND ADJUSTMENTS
TO REPLACE
FUSE (See Fig. 27)
Replace wit_.30 amp automotive+type plug+in fuse. The
fuse holder iS located in the engine compartment,directly
in front of the dash.
, FUSE
HOLDER
FIG. 27
TO REPLACE HEADLIGHT
BULB
•
Raise hood+
•
Pull bulb holder out of the hole in the backside of the
grill.
°
Replace bulb in holder and push bulb holder securely
back intothe hole in the backside of the grill+
,
Close hood+
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop runningor prevent it from starting+
•
Check wiring. See electrical wiring diagram in Repair
Parts section of this manual.
TO REMOVE HOOD AND GRILL (See Fig. 28)
CAUTION:
Muffler Is hot. Be careful
when removing retainer springs from
hood pivot brackets,
•
Raise hood,
•
Unsnap headlight wire connector+
•
Remove retainer spdngs from hood pivot brackets.
,
Stand in front of tractor. Grasp hood at sides, tilt
forward and lift off of tractor.
•
To reinstall, slide hood pivot brackets into slots in
frame. Replace retainer springs.
•
Reconnect headlight wire connector and close hood.
HOOD
HEADUGHT
CONNECTOR
REMOVE
RETAINER
SPRINGS
,,,,,
iJl,t,tm,,,,J,,J,,J,,..,JJl,
FIG. 28
22
Advertisement
Table of Contents
