Table of Contents
Advertisement
If at any time you wish to add a track to the list, press the CLEAR button to obtain the next step number.
Alternatively, to delete a previous entry, press CLEAR a second time to remove the last entry. Repeated
pressing of CLEAR will then erase each step in reverse order. So to delete an entire program sequence from
the memory, press CLEAR repeatedly until "PROGRAM 1" is shown in the display.
When the last track number has been entered, press PROGRAM a final time, then the
program sequence.
If you wish to check the selection before playing back your program, the CHECK button can be pressed to step
through each program entry in turn.
If during this check sequence the
play to the end of the sequence.
Otherwise, to play all the programmed tracks from the beginning of the sequence, press
remote control directly from programming. You can also start the sequence from any point by stepping through
the programmed sequence with CHECK button until the desired starting track is displayed.
The
button may be pressed to jump to the next track in the programmed sequence, or
►►|
the previous track in the sequence.
When all programmed tracks have played, the CD player stops. The same track selection can then be played
again by pressing the
►|▐▐
To repeat a programmed sequence continually, press REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note: The program contents will be cleared if you switch off the power, or load another disc. If,
however, the same disc is loaded again with the power still switched on, the program sequence is
retained in the memory.
TIME (remote control only)
Pressing the TIME button displays the word TRACK followed by the current track elapsed time. Pressing a
second time displays the word DISC then the total disk time elapsed.
DISPLAY (remote control only)
The CD display brightness can be controlled in three levels by pressing the DISPLAY button on the remote
control.
The original setting is maximum brightness, but by pressing the DISPLAY button once, brightness is reduced,
and a further press turns the display off.
M3 CD manual issue 1
PLAY
program play
button is pressed, the remaining part of your programmed selection will
►|▐▐
button on the front panel, or
PLAY
program rpt
1
0:41
on the remote control.
►
1
0:41
OPERATION
button to start the
►|▐▐
, or
on the
►|▐▐
►
button to obtain
|◄◄
Page 14 of 17
Advertisement
Table of Contents
