GE Monogram ZISS480DRISS Owner's Manual page 21

re and Cleaning
Built-In H_(]rigeralor.s
Using
the Master
L{ght switch
This teatm'e tm'ns off tile lights in tile t]'esh
food and freezer compartments.
The switch is located behind the grille panel
at tile top of tile refl'igerator. Li_t up tile panel
to access tile switch.
The switch is located
behindthe grille panel.
Type 1 bulb
replacement
NOTE: Before replacing tile bulbs, review
tile light bulb information and __I_NIN(;.
Replacing Type 1 bulbs located in lamps
behind the top pm_ in the fresh food
compaxtment and the bottom freezer basket
in the freezer compartment:
1. Set tile Master I.ight switch to tile OFF
position (see {Aing" the Ma.ster Lig'hl
s_vilch)
and allow the lamps to cool.
2. To access the lamps in the flesh food
compartment, remove tile Hmniditv Control
pan. See Drawer and Pan ICe, moral section.
Raise tile lid of tile pan up to expose tile
light cover.
To access the lamps in the fl'eezer
co,/lpart,lle,lt, re,llove
tile botto,ll tl"eezer
basket. See Freezer Baskets section.
3. On tile back wall there is a crowed light
shield. Grasp each end of the light shield.
Pull the shield toward you and the tabs
on the shield will release fl'om the slots in
the housing.
4. Remove tile glass above tile bulbs by pulling
it straight out.
NOTE: Always follow bulb i/,an/,t;ictt,rer's
directions tin" handling and replacing bulbs.
5. Remove tile bulb by holding tile base and
pulling straight up. Replace with a new bulb.
6. Replace the glass by sliding it into place.
Then replace the light shield by resting the
top lip of the shield on top of the light
housing. Then press the sides tmtil the tabs
pop into the slots in the housing.
• • ...... J°
WARNING - She light s hiel l ,,,,,st
be replaced
or tile heat from
tile bulb could
dama,*e tile refrigerator.
AVERTISSEMENT :
Vous devez remettre en place l'_cran _'llmni_re
pour ne pas endommager votre r_flJg_ratem"
avec la chalem" produite par l'ampoule.
7, Reset the Master i,ight switch to the ON
position.
21