Charging Instructions - Craftsman 934.716140 Owner's Manual

OPERATING INSTRUCTIONS
BATTERY EXPLOSION CAN KILL, INJURE, AND
CAUSE PROPERTY DAMAGE!
To reduce the risk of battery explosion, NEVER CONNECT BOTH
BATTERY CHARGER CLAMPS DIRECTLY TO THE TWO
POSTS OF A BATTERY.
4. Connect the POSITIVE (red) charger clamp to the POSITIVE
battery terminal.
5. Position yourself and the free end of the cable (attached to the
NEGATIVE battery terminal) as far away from the battery as
the cable will allow. Thenl WHILE FACING AWAY FROM THE
BATTERY, connect the NEGATIVE charger clamp to the free
end of the cable.
CHARGING INSTRUCTIONS
.
Set BATTERY TYPE SELECTOR for the type of battery to be
charged. See BATTERY TYPE SELECTOR in the CHARGER
CONTROLS AND FEATURES section of this manual.
2. Set FUNCTION SELECTOR to CHARGE.
.
Set AMP SELECTOR to the charging amps desired, for the
voltage battery being charged. See AMP SELECTOR in the
CHARGER CONTROLS AND FEATURES section of this manual.
4. See CHARGING TIME INSTRUCTIONS section to determine
how long to leave the charger connected to the battery.
BATTERY EXPLOSION CAN KILL, INJURE, AND
CAUSE PROPERTY DAMAGE! To reduce risk of battery
explosion, do not overcharge a lead-acid battery.
5. Plug the charger's AC powercord into a 120 volt, 60 Hz, AC
outlet.
IMPORTANT: Be sure to read the CHARGER CONTROLS AND
FEATURES section of this manual to verify that the charger has
been activated and is charging the battery. Certain battery
conditions can require pre-charge activation before charging will
begin. The indicator lights and ammeter will tell you if special
activation procedures are necessary.
16