Table of Contents
Advertisement
STEP 6: (SEE FIGURE 6)
•
Assemble an axle clip (S) and a wheel with the valve
stem facing out onto the axle. Assemble a hub cap
(P) by pressing or tapping it onto the axle. Repeat on
other end of axle.
WHEEL
AXLE
\
(P) HUB CAP
(S) AXLE CLiP
FIGURE 6
PADS (R)
LATCH
STAND
PLATE
(F) 5/16" x 3/4"
TRUSS HEAD
BOLT
(K) _16"
NYLOCK NUTS
LATCH STAND
BRACKET
FIGURE 7
STEP 7: (SEE FIGURE 7)
•
Attach two noise reduction pads (R) to the bottom of
the latch stand bracket.
Turn the assembled tongue, wheel support and
wheels over to the upright position. Place the latch
stand bracket onto the tongue between the latch lock
assembly and the raised tab. Place the poly tray onto
the wheel support and latch stand bracket. Fasten
the tray to the wheel support using eight 5/16" x 3/4"
truss head bolts (F) and 5/16" nylock nuts (K). Do not
tighten
yet.
Place the latch stand plate between the latch stand
bracket and the poly tray.
STEP 8: (SEE FIGURE 8)
Insert two 1/4" x 1-3/4" hex bolts (D) through the
handle tube as shown in figure 8. Holding the bolts in
place in the handle, insert the bolts through the holes
in the poly tray, allowing the legs of the handle to slip
beneath the latch stand bracket. Secure the two bolts
with two 1/4" flat washers (I) and 1/4" nylock nuts (J).
Do not tighten yet.
(J) I_"NYLOCK
NUT
(I) I_"FLAT
WASHER
(D) l_"xl-_4"
HEX BOLT
LATCH STAND
BRACKET
FIGURE
8
6
Advertisement
Table of Contents
