Installing Oracle Secure Backup On Linux Or Unix With Installob - Oracle Secure Backup Installation And Configuration Manual

Installing Oracle Secure Backup on Linux or UNIX with installob

Installing Oracle Secure Backup on Linux or UNIX with installob
To install the Oracle Secure Backup software on Linux or UNIX:
Ensure that the SCSI parameters for each tape device available.
1.
You can enter these parameters to create an attach point for each SCSI device as
part of the initial installation. Solaris 10 systems have special device configuration
procedures. See
Backup Attach Points"
Start the installob script.
2.
The Oracle Secure Backup setup script ends by asking to start the installation
process using the installob script. If you enter yes to this question, then the
setup script runs the installob script for you.
Otherwise, start installob from the command prompt. While logged in as
root, go to the Oracle Secure Backup home and enter the following command:
install/installob
The installob script displays a welcome message and tells you that most of its
questions have default answers, which you can select by simply pressing Enter.
Confirm the settings in the obparameters file.
3.
This step depends upon the value of the customized obparameters parameter
in the obparameters file described in
obparameters File"
■
■
Specify the host role.
4.
2-8 Oracle Secure Backup Installation and Configuration Guide
See Also:
Oracle Secure Backup Administrator's Guide for more information
■
about the preauthorized oracle user and RMAN backups.
Appendix B, "Oracle Secure Backup obparameters Installation
■
Parameters"
"Configuring the Solaris sgen Driver to Provide Oracle Secure
on page 2-18.
on page 2-7. The two possibilities are:
You have edited the obparameters file and set customized
obparameters to yes.
In this case, the installob script assumes that you have made the changes
you want in the obparameters file and uses those parameters during the
installation. Continue to step 4.
The customized obparameters parameter is set to no, which is the default.
In this case, the installob script asks if you have reviewed and customized
the obparameters file. Choose one of these options:
– Enter yes or press the Enter key to indicate that you do not want to
customize the obparameters file. Continue to step 4.
– Enter no to indicate that you do want to customize the obparameters
file. The installob script tells you to rerun the script after reviewing
obparameters. The installob script then exits.
"customized obparameters"
See Also:
the customize obparameters parameter.
"Configuring Installation Parameters in the
on page B-1 for details about