Unsupported Oracle Secure Backup Commands; Installation And Configuration - Oracle Secure Backup Installation And Configuration Manual

Unsupported Oracle Secure Backup Commands

The following Oracle Secure Backup commands are not supported for ACSLS tape
libraries:
importvol
■
extractvol
■
insertvol
■
clean
■
opendoor
■
closedoor
■

Installation and Configuration

The Oracle Secure Backup
32-bit media server.
Oracle Secure Backup installation assumes that the ACSLS hardware and software has
been correctly installed and configured. Oracle Secure Backup installation procedures
do not attempt to create or modify any ACSLS configuration files.
Oracle Secure Backup handles ACS tape devices no differently from other devices. The
Oracle Secure Backup device driver (if any) is installed, and special device files are
created. The data path is controlled solely by Oracle Secure Backup. ACSLS is not
involved.
creating Oracle Secure Backup objects for ACSLS devices is performed with the mkdev
command in
For ACSLS tape libraries, the usual host:devname attach point is replaced with
■
information identifying the acs of the tape library and the host name and port
where the associated ACS software is listening. A
barcodes are required.
For each
■
acs, lsm, panel, and drive. The acs is obtained from the tape library in which
the tape drive is contained.
media server
obtool with the following modifications:
tape drive contained within an ACSLS
See Also: Oracle Secure Backup Reference for mkdev syntax and
semantics
Installation and Configuration
attached to the ACSLS server must be a Linux
barcode reader is assumed, and
tape library, you must specify
Oracle Secure Backup and ACSLS D-5