Download Print this page

Craftsman 358.797550 Instruction Manual page 6

25cc/1.5 cu.in. 2-cycle 200 mph/400 cfm gasoline powered blower/vac

Advertisement

Available languages

Available languages

SHOULDER STRAP ADJUSTMENT
(for vacuum use only)
1. Hold the unit as shown.
2. Pass the shoulder strap over your
head and onto your right shoulder.
3. Extend your left arm toward the
rear of the vacuum bag.
4. Adjust shoulder strap until the vac-
uum bag/shoulder
strap seam lies
between your thumb and index
finger.
5. Make sure air flows freely from the
elbow tube into bag. If bag is kinked,
the unit will not operate properly.
KNOW YOUR BLOWER
READTHIS INSTRUCTIONMANUALAND SAFETY RULES BEFOREOPERATING YOUR
UNIT, Compare the illustrations with your unitto familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Upper
T_
Vacuum
Lower
Vacuum Tube
Primer Button
Vacuum Bag
_/[
,
T hrottlee _/(T_
Lever
Elbow Tube
Spark Plug--:--_
TBI°L
wer
_
THRO']-rLE
LEVER
The THRO]-i-LE LEVER is used to select
the desired engine speed and to stop the
engine. Move the throttle lever to the
•r_ position for full speed operation.
Move the throttle lever to the -4_ posi-
tion for idle speed. To stop the engine,
move the throttle lever to the STOP posi-
tion.
PRIMER BUTTON
The PRIMER BLFF]ONremoves air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
Choke Lever
_,,
Fuel Mix
Fill Cap
_,_Stoapfle
r
_Rear
Handle
the engine with fewer pulls on the starter
rope. Activate primer button by pressing
it and allowing it to return to its original
position.
CHOKE LEVER
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After engine
attempts to start, move the choke lever
to the HALF CHOKE position. Once en-
gine starts, move choke lever to the
RUN position.
-6-

Advertisement

loading