To Remove Hood And Grill Assembly; To Adjust Throttle Control Cable; To Adjust Choke Control - Craftsman 917.276120 Owner's Manual

TO REMOVEHOODAND GRILL ASo
SE_,_BLY
1. Rabe hood.
2. Unsnapheadlightwire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt towardengine and lift off of
tractor.
4. When replacinghood, be sure to re-
connect the headlightwire connector.
Idle Fuel Adjusting
Needle (if E(uipped)
Idle Speed
Ad Screw
Fhrottle
Control
Cable
Hood
Headlight Wire
Connector
Maintenance, repair, or replacement of
the embsion control devices and systems,
which are being done at the customers ex-
pense, may be performed by any non-road
engine repair establishment or individual.
Warranty repairs must be performed by an
authonzed engine manufacturer's servbe
outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
1. With engine not running, move throttle
control lever to fast position.
2. Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against screw.
Tighten clamp screw securely.
0167_
Stop Screw
Clamp Screw
Choke
Control
Cable
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be nec-
essary, check adjustment as described be-
low before loosening cable. If adjustment
is necessary, proceed as follows:
1. With engine not running, move choke
control (located on dash panel) to full
choke position.
2. Remove air cleaner cover, filter and
cartridge plate to expose carburetor
choke (See "AIR FILTER" in the Main-
tenance section of this manual).
3. Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw
securely.
4. Reassemble air cleaner.
Closed For Full
Choke
28