Warm/Cold Weather Starting; Automatic Transmission Warm Up; Purge Transmission - Craftsman 917.276120 Owner's Manual

27.0 hp, 54" mower electric start automatic transmission
Table of Contents

Advertisement

6.
Insert
key into ignition
and turn key
clockwise
to start position
and release
key as soon as engine
starts.
Do
not run starter
continuously
for more
than fifteen
seconds
per minute.
If the
engine
does not start after several
attempts,
push choke
control
in, wait
a few minutes
and try again.
If engine
still does
not start, pull the choke con-
trol out and retry.
WARM
WEATHER
STARTING
(50 ° F and
above)
7.
When engine
starts,
slowly
push choke
control
in until the engine
begins
to
run smoothly.
If the engine
starts to
run roughly,
pull the choke control
out
slightly
for a few seconds
and then
continue
to push the control
in slowly.
The attachments
and ground
drive can
now be used. If the engine
does not
accept
the load, restart
the engine
and
allow it to warm
up for one minute
using
the choke
as described
above.
COLD WEATHER
STARTING
(50 ° F and
below)
7.
When engine
starts,
slowly
push choke
control
in until the engine
begins
to run
smoothly.
Continue
to push the choke
control
in small steps allowing
the en-
gine to accept
small changes
in speed
and load, until the choke control
is fully
in. If the engine
starts to run roughly,
pull the choke
control
out slightly
for a
few seconds
and then continue
to push
the control
in slowly. This may require
an engine
warm-up
period
from several
seconds
to several
minutes,
depending
on the temperature.
NOTE:
In extreme
cold conditions,
if
engine
will not start you may need to dis-
engage
the motion
drive belt as follows:
1.
Be sure parking
brake is engaged.
2.
Remove
retainer
spring
from the drive
belt tension
handle to relieve
belt ten-
sion.
3.
Start engine
and allow it to warm
up for
three (3) minutes.
4.
Shut-off
engine
and engage
parking
brake.
5.
Engage
drive belt tension
handle
and
replace
the retainer
spring.
AUTOMATIC
TRANSMISSION
WARM
UP
Before
driving
the unit in cold weather,
the transmission
should
be warmed
up as
follows:
1.
Be sure the tractor
is on level ground.
2.
Place the motion
control
lever in
neutral.
Release
the parking
brake and
let the brake slowly
return
to operating
position.
3.
Allow
one minute
for transmission
to
warm
up. This can be done during
the
engine
warm
up period.
The attachments
can be used during
the engine
warm-up
period
after the
transmission
has been warmed
up and
may require
the choke
control
be pulled
out slightly.
NOTE:
If at a high altitude
(above
3000
feet) or in cold temperatures
(below
32 F)
the carburetor
fuel mixture
may need to
be adjusted
for best engine
performance
(see "TO ADJUST
CARBURETOR"
in the
Service
and Adjustments
section
of this
manual).
PURGE TRANSMmSSION
_ICAUTmON:
Never engage
or dis-
engage
freewheel
lever while the engine
is running.
To ensure
proper
operation
and per-
formance,
it is recommended
that the
transmission
be purged
before
operating
tractor
for the first time. This procedure
will
remove
any trapped
air inside
the trans-
mission
which
may have developed
during
shipping
of your tractor.
IMPORTANT:
Should
your transmission
require
removal
for service
or replace-
ment, it should
be purged
after reinstall-
ation
before operating
the tractor.
1.
Place tractor
safely
on level surface
with engine
off and parking
brake set.
2.
Disengage
transmission
by plac-
ing freewheel
control
in disengaged
position
(See "TO TRANSPORT"
in this
section
of manual).
3.
Sitting
in the tractor
seat, start engine.
After the engine
is running,
move
throttle
control
to slow position.
Disen-
gage parking
brake.
4.
Move motion
control
lever to full
forward
position
and hold for five (5)
seconds.
Move lever to full reverse
position
and hold for five (5) seconds.
Repeat
this procedure
three
(3) times.
NOTE:
During
this step there
will be no
movement
of drive wheels.
The air is being
removed
from hydraulic
drive system.
5.
Move motion
control
lever to neutral
(N) position.
Shutoff
engine
and set
parking
brake.
6.
Engage
transmission
by placing
free-
wheel
control
in engaged
position
(See
"TO TRANSPORT"
in this section
of
manual).
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents