Leveling The Range - GE JGB800 Owner's Manual & Installation Instructions

Installation Instructions
"H'H
[] ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY
Air' adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
The air adjustment shutter for the top fbroil}burner is in
the center of the rear well of the oven
The shutter for the bottom (oven) burner is near the back
wall behind the warming drawer. Remove the drawer See
the Care and cleaning of the range section
To adjust the flow of air to either burner, loosen the
Phillips heed screw and rotate the shutter toward open
or closed position as needed.
The flames for the top (broil) burner should be steadg with
approximatelg 1" blue cones and should not extend out
over the edges of the burner baffle
To determine if the bottom burner flames are burning
properly, remove the oven bottom. Flames should have
approximately 1" blue cones and, if range is supplied
with natural gas, should burn with no Mellow tipping
(With most LP gas, small gellow tips at the end of outer
cones are normal} Flames should not lift off burner ports
If lifting is observed graduallg reduce air shutter opening
until flames are stabilized
iii i i iiii
[_ ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY {CONT_}
To remove the oven bottom:
A. Remove the screws holding down the rear of the oven
bottom
& Grasp the oven bottom at finger slots on each side
C. Lift the rear of the oven bottom enough to clear the lip
of the range frame, push it back, and then pull it up
and out.
tUll,Ullllll till iiiJ iiui Jl iiii ii iiii
I_] LEVELING THE RANGE
A. Install the oven racks in the oven and position
the range where it wilt be installed
Raise Lower
range range
range
(onsomemodels) (on somemodels)
B.Check for levelness bg placing a spirit level or a cup,
partiollg filled with water, on one of the oven racks
tf using a spirit level, take two readings-with the level
placed diagonatlg first in one direction and then the
other
C, Remove the drawer See the Ca_eand cleaning of the
range section The front leveling legs can be adjusted
from the bottom and the rear legs can be adjusted
flom the top or the bottom
DoUse an open-end or adjustable wrench to adjust the
leveling legs until the range is level
E,After the range is level, slide the range awag from the
wall so that the Anti-Tip device can be installed
.............. 50