Troubleshooting Tips Before You Call For Service - GE GTS22JCPARCC Owner's Manual & Installation Instructions

Before you call for service.., ww .GEAppliances.co
Troubleshooting tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Possible Causes What To Do
Refrigerator in defrost cycle. • Wait about 40 minutes for defrost cycle to end.
The controls are set to • Move the reliigerator and freezer control to a
the 0 (off)position. temperature setting.
Refrigerator is unplugged. • Push the plug completely into the outlet.
The fuse is blown/circuit * Replace fuse or reset the hreaken
breaker is tripped.
Rollers need adjusting. * See BoOers.
Normal when refrigerator • Wait 12-24 hours for the refrigerator to completely
is Ftrst plugged in. cool down.
Often occurs when large • This is normal.
amounts of food are
placed in refrigerator.
Door left open. • Check to see if package is holding door open.
Hot weather or frequent • This is normal.
door openings.
Temperature controls • See About the controls.
set at the coldest
setting.
Temperature control not set • See About the controls.
cold enough.
Warm weather or frequent • Set the temperature conn'ol one step colden
door openings. See About the controls.
Door left open. • Check to see if package is holding door open.
Door left open. • Check to see if package is holding door open.
Too frequent or too long
door openings.
Icemaker power switch •Setthepowerswitchtothet(On)position.
(o_some_,odels)
is in the 0 (Off)position_
Water supply turned off or •Seelnstallingthewaterlino.
not connected.
Freezer compartment • Wait 12-24 hours for the refrigerator to completely
too warm. cool down.
Piled up cubes in the storage • Level cubes by hand.
bin cause the icemaker
to shut off.
Ice cubes stuck in icemaker. • Turn off the icemakel; remove cubes and turn the
(Green power light on icemaker hack on.
....... ieemaker blinking).
Icemaker power switch is
in the I (on)position, but the
water supply to the refrigerator
has not been connected.
• Set the power switch to the 0 (Off)position. Keeping it
in the I (on) position will damage the water valve.
25