Table of Contents
Advertisement
UNPACKING
Thisproducthasbeen shipped completely a ssembled.
[] Carefully r emove thetoolandanyaccessories fromthe
box.Makesurethatallitemslistedinthepacking list
areincluded.
[] Inspect t hetoolcarefully t o makesurenobreakage o r
damage occurred duringshipping.
[] Donotdiscard thepacking material untilyouhave
carefully inspected andsatisfactorily o perated thetool.
[] If anypartsaredamaged or missing, please call
1-800-932-3188 forassistance.
PACKING
LiST
Cut-Out Saw with 1/8 in. collet
1/4 in. collet
1/8 in. collet
Auxiliary Handle
Auxiliary Handle Cap
Auxiliary Handle Screws (2)
1/8 in. Drywall Bit
1/8 in. Plywood Bit
Circle Guide
Wrench
Hex Key
Operator's Manual
_L
WARNING:
If any parts are missing do not operate
this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
A
WARNING:
Do not attempt to modify this tool
or create accessories not recommended
for use
with this tool. Any such alteration or modification
is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING:
To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when assembling
parts.
INSTALLING/REMOVING
AUXILIARY
HANDLE
ASSEMBLY
See Figure 2.
An auxiliary handle is packed with the saw for ease of
operation and to help prevent loss of control. An auxiliary
handle cap has also been supplied to cover the auxiliary
handle slot when the handle is not in use.
To install auxiliary handle:
[] Remove hex key from hex key storage area.
[] Remove auxilary handle cap (if attached) by removing
auxilary handle cap screws with hex key.
[] Insert auxiliary handle into slot.
[] Install and tighten screws through slots on the auxiliary
handle into cut-out saw with hex key.
[] Insert hex key back into hex key storage area.
To remove auxiliary
handle:
[] Remove hex key from hex key storage area.
[] Remove screws in auxiliary handle with hex key.
[] Remove auxiliary handle and replace with auxiliary
handle cap.
[] Install and tighten screws through slots on the auxiliary
cap into cut-out saw with hex key.
[] Insert hex key back into hex key storage area.
NOTE: Always hold the tool by its motor housing or the
auxiliary handle.
REMOVE
CAP
AUXILIARY
HANDLE
SCREW
Fig. 2
Advertisement
Table of Contents
