Table of Contents
Advertisement
BATTERY PACK
CHARGER
RED
YELLOWLED
GREENLED
LED Fig. 3
[] After normal usage, a minimum of 1 hour of charging
time is required to fury recharge battery pack.
[] The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
[] Do not place the charger and battery pack in an area
of extreme heat or cold. They will work best at normal
room temperature.
NOTE: The charger and battery pack should be placed
in a location where the temperature
is more than 50°F
but less than 100°F.
[] When batteries become fully charged, unplug the
charger from power supply and remove the battery
pack.
CHARGING
A HOT BATTERY
PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately
30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
NOTE: This situation only occurs when continuous
use
of the tool causes the batteries to become hot. It does
not occur under normal circumstances.
Refer to CHARG-
ING A COOL BATTERY PACK for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances,
return both the battery
pack and charger to your nearest Sears Repair Center for
electrical check.
INSTALLING
BATTERY
PACK
See Figure 4.
[] Place battery pack on the cut-out saw.
[] Align raised rib on battery pack with groove in saw's bat-
tery port.
[] Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured on the tool
before beginning operation.
,_
WARNING:
When placing the battery pack in the
tool, be sure the switch is not in the ON position.
Since there is no trigger lock on this tool, the cut-
out saw will start automatically
if the battery pack is
installed and the switch is in the ON position.
CAUTION:
When placing battery pack in the tool, be
sure raised rib on battery pack aligns with the bottom of
the tool and latches into place properly. Improper instal-
lation of the battery pack can cause damage to internal
components.
REMOVING
BATTERY
PACK
See Figure 4.
[] Locate latches on side of battery pack and depress both
sides to release battery pack from the cut-out saw.
[] Remove battery pack from the cut-out saw.
BATTERYPACK
\
LATCHES
Fig. 4
11
Advertisement
Table of Contents
