Table of Contents
Advertisement
PROGRAMMING
NOTICE: If this Security+_ garage door opener is operated with a non-rolling code transmitter, the technical
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented.
The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security,I -_ remote controls.
To Add
or Reprogram
a Hand.held
Remote
Control
USING THE "LEARN"
BUTTON
1. Press and release the "learn"
button on the motor unit. The learn
indicator
light will glow steadily for
30 seconds.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
2. Within 30 seconds,
press and hold
the button on the hand-held
remote* that you wish to operate
your garage door.
To Erase
All Codes
From
Motor
Unit
Memory
To deactivate
any unwanted
remote,
[_
[]
first erase all codes:
.........
Press and hold the "learn" button on
motor unit until the learn indicator
light goes out (approximately
6 seconds). All previous
codes are now erased. Reprogram
each remote or
keyless entry you wish to use.
*3.Function
Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security+ _ 3-Function
remote or compact
remote can be
programmed to operate
other Security÷ ®garage
door openers.
35
Advertisement
Table of Contents
