GE AEE08 Owner's Manual And Installation Instructions page 10

Window Installation instructions
[] iNSTALL THE CASE iN THE
WINDOW
[] Open the window and mark the centerline of
the window stool.
rB1 Carefully place the case on the window stool
and align the center mark on the bottom front
with the centerline of the stool.
rc-] Pull the window down behind the top
mounting rail.
NOTE: Do not shut the window so tightly that
movement of the accordion panels is
restricted.
@
Select the position that will place the sill
supports near the outermost point on the sill.
Place the short side of the sill supports, on the
case bottom, toward the window. Attach the
sill supports to the case track hole in relation
to the selected position using 2 Type B screws
in each support.
A CAUTION: Do notinstall this air
conditioner in a window if the bolts do not
contact the window sill.
\
Long side
of sill
supports
OUTSIDE
[] Adjust the bolt and the nut in each support so
that the case is installed with
a slight tilt to the outside. Use a level; no more
than 1/2 bubble will be the correct case slant
to the outside.
^ CAUTION: Ifthe sill
s upport
bOltS
do not contact the window sill or if you have a
window without a sill you must order accessory
kit RAK87 to properly install this air conditioner.
10
iNSTALL THE CASE iN THE
WINDOW (CONT.)
[] Secure the case to
the window stool
by using
3 Type D screws. Sill
support
I
Pull the accordion
panels to each
window sash track.
Attach them on each
side to the window
sash and the window
stool using
4 Type C screws.
@
B]
SECURE THE CASE IN THE WINDOW
AND INSTALL THE FOAM TOP
WINDOW GASKET
-_CAUTION'.
To prevent broken glass Vinyl
or damage to windows,
on vinyl or other similarly
constructed windows,
attach the support bracket
to the window side jam.
Attach the window
locking brackets (on one
each side) with Type C
screws.
Wood
Cut the foam top window gasket to the window
width.
Stuff the foam
between the glass
and the window
to prevent air and
insects from getting
into the room.
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal.