Craftsman EZ3 917.258470 Owner's Manual page 25

Table of Contents

Advertisement

SERVICE AN
ADJUSTMENTS
POSITIVE TERMINAL
NEGATIVE TERMINAL
CABLES
;HARGED
BATTERY
POSITIVE TERMINAL
NEGATIVE
TERMINAL
FWGo 29
TO REPLACE
HEADLIGHT
BULB
=
Raise hood.
,
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
,
Close hood.
TO REMOVE
HOOD
AND
GRILL
ASSEMBLY
(See Fig. 30)
',
Raise hood,
Unsnap headlight wire connector.
=
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
,,
To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
F|G. 30
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorty, stop running, or prevent it from starting,
,
Check wiring.
See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-in fuse,
The
fuse holder is located behind the dash.
25

Advertisement

Table of Contents
loading

Table of Contents