Frigidaire CGLES389FB3 Use & Care Manual page 29

Drop-in/slide-in models
Table of Contents

Advertisement

OCCURRENCE
POSSmBLE
CAUSE/SOLUTmON
Metalmarks,
Brown streaks or specks,
Areas ofdiscoloration with
metallic sheen,
Poorbaking results,
operation,
Flames inside ovenor smok-
ingfromvent,
Ovensmokes excessively
during broiling,
Self-cleaning cycledoesnot
work,
Soilnotcompletely removed
afterself-cleaning cycle,
(1}Sliding or scraping ofmetalutensils oncooktop surface, D onotslidemetal u tensils on
cooktop s urface, Useaceramic-glass cooktop c leaning c ream toremove t hemarks, "Cooktop
Cleaning - Ceramic G lass Cooktop M odels" section under G eneral Cleaning,
(1} Boilovers a recooked ontosurface, U serazorbladescraper t o remove soil,
"Cooktop
Cleaning - Ceramic Glass Cooktop Models" section under General Cleaning,
(1} Mineral deposits from water and food, Remove using a ceramic-glass cooktop cleaning
cream, Use cookware with clean, dry bottoms,
(1} Many factors affect baking results, Make sure the proper rack position is used, Center
food in the oven and space pans to allow air to circulate, Allow the oven to preheat to the set
temperature before placing food in the oven, Try adjusting the recipe's recommended tem-
perature or baking time, if you feel the oven is too hot or cool, see "Adjusting
Oven Tem-
perature"
in the Electronic Oven Control guide,
(1} A cooling fan may automatically turn on and off to cool internal parts, it is normal, and the
fan may continue to run even after oven is turned off,
(1} Excessive spillovers in oven, Set self-clean cycle for a longer cleaning time, (2} Exces-
sive spillovers in oven, This is normal, especially for pie spillovers or large amounts of grease
on the oven bottom, Wipe up excessive spillovers before starting the self-clean cycle, if
flames or excessive smoke are present, stop the self-clean cycle and follow the steps under
"Stopping or interrupting the Self-Cleaning Cycle" in the Electronic Oven Control guide,
(1} Make sure oven is opened to BroiJ Stop Position.
(2} Meat too close to the element,
Reposition the rack to provide proper clearance between the meat and the element, Preheat
broil element, Preheat broil element for searing, (3} Grid on broiler pan wrong side up and
grease not draining, Always place grid on your broiler pan with ribs up and slots down to allow
grease to drip into pan, (4} Grease has built up on oven surfaces, Regular cleaning is neces-
sary when broiling frequently, Old grease or food spatters cause excessive smoking,
(1} Self-cleaning cycle was interrupted, Follow steps under"Stopping or interrupting the Self-
Cleaning Cycle" in the Electronic Oven Control Guide, (2} Control(s) not set properly, Follow
instructions under"Oven Cleaning" in the Electronic Oven Control Guide,
(1} Failure to clean bottom, front, top or oven, frame or door area outside oven seal, These
areas are not in the self-cleaning area, but get hot enough to burn on residue, Clean these
areas before the self-cleaning cycle is started, Burned-on residue can be cleaned with a stiff
nylon brush and water or nylon scrubber, Be careful not to damage the oven seal,
Avoid
Transportation
Damage
to your
Range
if you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take the
following precautions:
1, Screw in the levelling legs under the range,
2, Remove the racks and other utensils from the oven, and from the lower drawer,
8, Use adhesive tape to firmly secure the door and the drawer to the side panels, Also attach the electric power cord in the
same manner,
4, Use a two-wheeled
trolley with strap and fasten the range to it, Cover the appliance with a heavy blanket to prevent
scratches and dents,
5, Avoid pulling or pushing the control panel when moving the appliance,
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents