Door Removal - Frigidaire FRT18S6AQ2 Use & Care Manual

Door Removal and Reversal instructions (continued)
NOTE: Some modeJs na_e "pOCKEt" handles, which are recessed into the sides Df tne door. On these mode_s, only
the hinges wm need to de reversed.
TO REMOVE FREEZER HANDLE:
Handles -nay be easier ic reverse While doors are off.
q Remove _wo screws a_acn_ng handle [o bottom of freezer door.
2 Remove snor_ trim 8iece oy sliding trim s_ralgnt up and off 3f nandle
DracKet.
3, Remove screw attaching too of handle _o door
4 Magnetic Namepmate Modems: Gently pry magnetic nameolate frame from
dOOr Remove nameplate from is frame, turn frame osloe Gown and
nsta - o!o handle noles. Insert magnetic nameslate hid frame.
Serf-Adhesive Narnepmate Modems: Gently pee! 3ff nameolate from door
and reapply over old qandle holes.
TO ATTACH FREEZER HANDLE:
q Reinsta nandle on coooslte side using same hole as nameDta_e.
2 AttaCh handle to bottom of door.
3, Slide trim oiece straight Gown onto handle bracket.
14_ _' Namepmal:e
Screw-==_ _some models',
iii i i i
soBf AdhesiVe
Namepmate Namepmate 1
(some models
Lock Handle
over
TO REMOVE FREEZER HANDLE:
(Handles may be easier to reverse while doors are off.)
1. Remove two screws attaching handle to bottom of freezer door.
2. Swing bottom of handle away from the door and slide handle straight up
and off of dovetail button.
3. Remove screw and dovetail button and install on other side, using the
same holes as nameplate.
4. Magnetic Nameplate Modems: Use putty knife to gently pry magnetic
nameplate frame from door. Remove nameplate from its frame, turn frame
upside down and install in old handle holes. Insert magnetic nameplate
into frame.
Serf-Adhesive Nameplate Modems: Use putty knife to gently peel off name
plate from door and reapply over old handle holes.
TO ATTACH FREEZER HANDLE:
1. Start with handle offset away from door. Place top of handle over dovetail
button, swing handle into an upright position and pull downward, locking it
into place.
2. Secure bottom of handle with two screws removed earlier.
TO REMOVE FREEZER HANDLE:
(Handles may be easier to reverse while doors are off.)
1. Remove two screws attaching handle to bottom of freezer door.
2. Remove button plug using edge of putty knife.
3. Remove screw on side of freezer door and remove handle.
TO ATTACH FREEZER HANDLE:
1. Secure side of handle to door and replace button plug.
2. Secure handle to bottom of door.
NOTE: To remove freezer handle, refer to figure 3 on page 9,
Button
Plug-