Coil Surface Element; To Remove And Replace Surface Elements And Drip Bowls; Special Cleaning Instructions For Mineral Deposits And Discolorations - Frigidaire Gallery Series Owner's Manual

Drop-in/slide-in model
Hide thumbs Also See for Gallery Series:
Table of Contents

Advertisement

General Cleaning (continued)
Ceramic-Glass
Cooktop
Cleaning
(some models)(continued)
DO USE ON CERAMIC GLASS COOKTOP
1.
Baking
soda
2.
Non-impregnated
plastic and nylon
pads.
3.
For burned
on material,
scrape with
single-edged
razor blade, held at a 30 ° angle.
4.
Ceramic
glass cleaning
cream.
DO NOT USE ON CERAMIC GLASS COOKTOP
1.
Avoid
pads, that can leave marks and scratches.
2.
Avoid
heavy-duty
cleansing
powders,
these can scratch,
depending
on their abrasiveness
and cleaning
pressure
applied.
3.
Avoid
chemical
oven cleaners.
These can etch the cooktop
surface and are caustic.
4.
Avoid
using bleach
and don't
use ammonia.
SPECIALCLEANING INSTRUCTIONS FOR MINERAL DEPOSITSAND DISCOLORATIONS
Problem:
A gray stain that is not removed
when using cleaner cream.
Cause:
Condensation,
when cooking,
often
collects
and drips from cookware.
The minerals
found
in water
supply and foods
may
cause a gray or brown
film develop
on cooktop.
This film is so thin it cannot
be felt and appears
to be under cooktop.
To prevent:
Daily and proper
use of cleaner cream.
To remove:
Wet surface with water
and sprinkle
on cleaner cream.
Scrub with
clean, damp
paper towel
until stain disappears.
Clean remaining
paste away with
damp
paper towel.
Apply
dab of cleaner cream and polish with
a clean paper towel.
WARNING
Do not use cleaners on a heated
surface.
Fumes could be hazardous.
Wait for area to cool before cleaning.
Do not use cleaner cream to clean porcelain,
paint or aluminum.
Coil Surface
Element
(some models)
To Remove
and
Replace
Surface
Elements
and
Drip
Bowls
(some models)
Be careful
not to bend terminal
ends
when
replacing
elements
after cleaning.
ATTENTION:
Never leave covers on the coil elements
as they could be permanently
damaged
if the coil
is turned
on by accident.
Prior to cleaning
the coil elements
make
sure they are cold and that control
knobs
are turned
to
OFF
Coil elements
clean themselves
when they are turned
on.
Coil elements
and drip bowls are removable
and allow to clean the drip bowls.
To remove
a coil element,
push against
the front
edge and lift element
up and out.
To clean by hand, wash the drip bowls in hot sudsy water. For hard to remove spots, use nylon scrubber
with
soap. Rinse and dry will still warm.
_
Never immerse
coil elements
in water.
General16
information

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gallery professional series

Table of Contents