Setting Minute Timer; Setting Lockout Feature - Frigidaire FPCS3085LFA Use & Care Manual

SETTING MINUTE TIMER
The TIMER ON'OFF padcontrols theMinuteTimerfeature.
The Minute Timer serves as an extra timer in the kitchen
that will beep when the set time has run out, It does not
start or stop cooking, The Minute Timer feature can be
used during any of the other oven control functions, Refer
to "Minimum and Maximum Contro! Pad Settings" for time
amount settings,
To set the Minute Timer (example for 5 minutes)
1. Press TIMER ON.OFF." .... "will a ppearand"Timer"
will f lash inthedisplay.
2. Pressthe number pads to setthe desired time inthe
display.
3. PressSTART. The timewill beginto count down with
"5:00" and "Timer" will stayinthedisplay.
Note: If START isnotpressedthetimerwill return to the
timeof day after 25 seconds.
4. When thesettime hasFUnout, "End" and "Timer" will
show inthe display. The clock will s ound with3 beeps
every5 secondsuntil T IMER ON.OFF ispressed.
To cancel the Minute Timer before the set time has
run out
1. Press TIMER ON.OFF. The display will r eturn t othetime
of day.
SETTING LOCKOUT FEATURE
The _ pad controls the Lockout feature. The Lockout feature
automatically locks the cooktop controls, the oven door and
prevents the oven from being turned on. It does not disable
the clock, Minute Timer or the interior oven lights.
To activate the Oven Lockout feature
i. Pressand hold_ for3 seconds.
2. After3 seconds "door Loc" will appear in the oven
control display, a beep will s ound and "DOOR" and l(:Pl
will flash inthe display. Once the oven door islocked
the "DOOR" and I_ indicators will stop flashing and
remain on along with the "Loc':
To reactivate normal oven operation:
1. Press and hold _ for 3 seconds. After 3 seconds"door
OPn" will appear and a beep will sound. The "DOOR"
and i_ will flash in the display until the oven door has
completely unlocked
2, The oven is again fully operational.
SETTING ADD 1 MINUTE FEATURE
The ADD 1 MINUTE pad is used to set the Add 1 Minute
feature. When the ADD :L MINUTE pad is pressed, 1
minute is added to the Minute Timer feature if this feature
is already active. If the Minute Timer feature is not active
and the ADD 1 MINUTE pad is pressed, the Minute Timer
feature will become active and will begin counting down
from 1 minute.
During lockout feature surface elements can not be used
(see ESEC Lockout Feature)