Sleep Feature - Frigidaire FRA086HT110 Use & Care Manual

Table of Contents

Advertisement

Operating
Instructions
(continued)
TO USE THE ENERGY SAVER
FEATURE;
ternp/timer
auto
[] hi
reed
1o
heat
cool
energy saver
._______------
DO THIS;
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
YOU WILL SEE:
temp/dmer
auto
[] hi
med
heat
COOl
[] energy saver
fanon@
Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 seconds
at 10 minute intervals until the room temperature
is above the set temperature,
at which time the compressor turns back on.
FIRST
DO THIS;
PRESS
TIMER BUTTON
TIMER:
DELAY STOP / START
FEATURE
temp/dme_
1
THEN
DO THIS:
PRESS
UP/DOWN
SET BUTTONS
YOU WILL SEE HOW MUCH TIME
IS CHOSEN:
temp/timer
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER
button,
then adjust
timer
setting,
tap or hold the UP arrow
( A ) or the DOWN arrow
( V ) to change
delay
timer
at 0.5 hour increments,
up to 10 hours,
then
at 1 hour increments
up to 24 hours.
The control
will count
down the time
remaining
until start
(8, 7.5, 7, etc.).
The Delay Start Operation
automatically
selects cooling
with
maximum
Fan speed
(if Cool,
Energy
Saver, or Fan Only was the last mode selected)
or heating
with
maximum
Fan speed (if Heat was the last mode
selected.
Note: On 115V models
only low speed can be selected.)
The temperature
maintained
will be the same as previously
set. To change
the set temperature,
press "COOL" then
Up or Down arrows
until the desired
temperature
is indicated
on the display.
After
5
seconds,
the control
will automatically
change
the display
back to the hours
remaining
until the unit will start/stop.
Pressing
the
unit On/Off
button
at any time will cancel the Delay Start/Stop
function.
The Delay Start/Stop
Feature
will work until the unit either
starts or stops. Once that happens
the above steps have to be repeated
again.
SLEEP FEATURE;
YOU WILL SEE:
temp/timer
_¢_rn£te
sensing
DO THIS:
PRESS
SLEEP BUTTON
temp/timer
rem£te
senszn#
Note: In this mode the selected temperature
will increase by 2 °F 30 minutes after the mode is selected. The temperature
will then
increase by another 2 °F after an additional 30 minutes. This new temperature
will be maintained for 7 hours before it returns to
the originally selected temperature.
This ends the "Sleep" mode and the unit will continue to operate as originally programmed.
The "Sleep" mode program can be cancelled at any time during operation by again pressing the "Sleep" button.
02009
Electrolux
Home Products,
Inc.
All rights
reserved.
/

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fra144ht210Fra08eht110

Table of Contents