To Use Energy Saver; Using Timer; Sleep Feature - Frigidaire Air Conditioner Use & Care Manual

Operating Instructions
(continued)
TO USE THE ENERGY SAVER
FEATURE:
temp/timer
DO THIS;
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
YOU WILL SEE:
Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off. The fan then cycles on for 20 seconds
at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on.
TIMER: DELAY STOP / START
FEATURE
FIRST
_i
OO THIS;
PRESS
TIMER BUTTON
tamp/timer I
THEN
DO THIS:
PRESS
_ UP/DOWN
_ SET BUTTONS
YOU WILL SEE HOW MUCH TIME
IS CHOSEN:
temp/timer
@
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( A ) or the DOWN arrow ( V ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
Energy Saver, or Fan Only was the last mode selected) or heating with maximum Fan speed (if Heat was the last mode selected.
Note: On 115V models only low speed can be selected.) The temperature maintained will be the same as previously set. To change
the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated again.
SLEEP FEATURE: YOU WILL SEE:
temp/timer
remote
sensmg
DO THIS;
PRESS
SLEEP BUTTON
temp/timer
remote
sensing
Note: In this mode the selected temperature will increase by 2 °F 30 minutes after the mode is selected. The temperature will then
increase by another 2 °F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to
the originally selected temperature. This ends the "Sleep" mode and the unit will continue to operate as originally programmed.
The "Sleep" mode program can be cancelled at any time during operation by again pressing the "Sleep" button.
@2009 Electrolux Home Products, Inc. All rights reserved.