Table of Contents
Advertisement
Operating
Instructions
(continued)
REMOTE SENSING FEATURE
(on some models):
DO THIS:
ESS REMOTE
SENSING
RT BUTTON
FAULT CODES:
YOU WILL SEE;
LIGHT
pulsing
( On & Off intermittently
).
Note: This feature can be activated
from the remote
con-
trol ONLY, the unit must be in a cooling
mode.
To activate
the remote
sensing feature,
point the remote
control towards
the unit and press the remote sensing
Start button.
Next, use the "A_'
"buttons
to set the de-
sired temperature
at the remote.
(Note that the set tempe-
rature will only be displayed
on the unit itself ), The LIGHT
on the unit control
will pulse to indicate
it received the
signal. The LIGHT on the remote control
will pulse each
time it sends a signal. It will periodically
send this signal
until the feature
is deactivated
by pressing the remote sen-
sing Stop button.
If the unit does not receive the remote
sensing signal during
any 3 minute
interval,
the unit will
beep to indicate the remote sensing mode has ended.
The
display on the remote control
indicates
the temperature
at
the remote ONLY.
NOTE: The Remote Sensing function
is terminated
either
by using the Remote Sensing Stop button
or the main
ON/OFF button
on the unit.
If the display reads "AS" or "ES', a sensor has failed. Contact your
Authorized Frigidaire Service Center.
'\
_y
TO TURN UNIT OFF:
DO THIS;
PRESS ON/
OFF BUTTON
@2009
Electrolux
Home Products,
Inc.
All rights
reserved,
f_
Advertisement
Table of Contents
