Page 1
|nstallation instructions READ BEFORE iNSTALLiNG UNiT MS II Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) When handling unit, be careful to avoid cuts Lower sash must open sufficiently to allow a clear vertical from sharp metal edges and aluminum fins on opening of 14 inches (356 mm).
Page 2
How to Install NOTE: "Fop Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table.
Page 3
Place frame lock between the frame foam seal and insert in the space extensions and the window sill as shown between the upper lower sashes (riG.13). (Fig. 8). Drive 3/4" (19 ram) locking screws through frame lock into the sill (FIG.