Table of Contents
Advertisement
Available languages
Available languages
Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM:
Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
Code Certification:
Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent
safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-In Pressure:
While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to a certain low
level the motor will restart automatically.
The low
pressure at which the motor automatically
restarts is
called "cut-in"
pressure.
Cut-Out Pressure:
When an air compressor
is
turned on and begins to run, air pressure in the air
tank begins to build.
It builds to a certain high pres-
sure before the motor automatically
shuts off - pro-
tecting your air tank from pressure higher than its
capacity.
The high pressure at which the motor shuts
off is called "cut-out"
pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.
Accessories
•
In Line Filter
•
Tire Air Chuck
•
Quick Connector Sets
(various sizes)
•
Air Pressure Regulators
•
Oil Fog Lubricators
•
Air Hose:
1/4", 5/16" OR 3/8"
I.D.
in various lengths
Specialty
Tools
Socket
Driving
•
Air Brush
•
3/8" Impact/Butterfly
Wrench
•
inflating/Blow
Gun
•
3/8" Ratchet
•
Grease Gun
•
1/4" Ratchet
•
Caulk Gun
Material
Shaping
•
Engine Cleaner
•
2.625" Hammer
Carpentry
Tools
•
1.625" Hammer
•
Finishing Nailer / Stapler
•
Reciprocating
Saw
•
Construction
Nailer / Stapler
•
Nibbler
Spray Painting
•
Multi-Purpose
Spray Gun
•
Automotive
Spray Gun
Contents
of Carton
1 - Air Compressor
4 - Rubber Feet
3.
Attach the four rubber feet to the unit's legs using
the four screws removed in step 2.
NOTE: Flat side of rubber feet goes against unit legs.
Tools
Required
for Assembly
1 - 3/8" socket or nut driver
Assemble
Rubber
Feet
1.
Carefully place unit on side opposite of controls.
2.
Using a 3/8 inch socket or nut driver remove the
screws attaching the unit to the shipping pallet.
NOTE: These screws will be used to install the rub-
ber feet.
_
Rubber Foot
_-
Screw
7- ENG
D23343
Advertisement
Chapters
Table of Contents
