Installation Requirements - Friedrich UE10 Installation & Operation Manual

Installation
Remove packing sheet from the back of the sleeve, and
packing corner and blue tape from the air conditioner.
INSTALLATION REQUIREMENTS
If you use an existing wall sleeve, you should measure
its dimensions.
Install the new air conditioner according to these
installation instructions to achieve the best performance.
All wall sleeves used to mount the new air conditioner
must be in good structural condition and have a rear grille
to securely attach the new air conditioner. (FIG. 1)
Installing the FRIEDRICH USC sleeve ensures optimal
performance of the new air conditioner. (FIG. 2)
19-2//32"
(499 mm)
Air Conditioner
/3/32"
mm)
8"(458mr'n)
FIG. 1
INSTALLATION HARDWARE
s
2 Size options
ITEM NAME OF PARTS i Q'TY
_1_ PLASTIC GRILLE 1
HORIZONTAL INSULATION STRIPS 2
AROUND INSULATION STRIPS 2
(49 SUPPORT BLOCK 2
BAFFLE 1
_6_ TRIM FRAME 2
SHIM 2
_8_ PLASTIC NUTS AND WASHER SCREWS i 4
<9_ GRILLE REAR 1
25-7/s"
_{656 mm)
(394mm}
aluminum metal grill
FRIEDRICH Wall Sleeve FIG. 2
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections. SAVE CARTON
for storage and this OWNER'S MANUAL for future
reference. The carton is the best way to store unit
during winter or when not in use.
To avoid risk of personal injury, property damage,
or product damage due to the weight of this
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injuryor strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
will be installed. Be sure itwill support the weight
of the unit over an extended period of time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
• Make sure air conditioner does not fall during
installation.
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratchet
• Tape measure
• Electric drill
• 1/4-inch drill bit