Advertisement
Available languages
Available languages
Contents
of Carton
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
2 - Screws, .25 x 1.50
1-
Handle
1 - Handle Grip
2 - Screws, #10-16 x 1.00
Tools Required for
Assembly
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
Installing
Handles,
Wheels,
and Molded
Foot
Bumpers
_
The wheels
and handle
do not provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
1.
Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
Compressor
Saddle
It will be necessary
to brace or support
one side of the outfit when
installing the wheels because the
compressor will have a tendency to
tip over.
3.
Install one shoulder bolt and one
nut for each wheel. Tighten
securely. The outfit will sit level
if the wheels are properly
installed.
4\\
Wheel
/
Nut
/
Shoulder Bolt
4.
Clean and dry underside of air
tank leg opposite wheels.
Remove the protective strip from
the adhesive backed molded foot
bumpers. Attach the foot
bumpers to the bottom of leg on
each end.
Press firmly into
place.
D30085
10-ENG
Advertisement
