CARTON
CONTENTS
The following parts are shipped loose with your
pressure washer:.
•
Main Unit -- pressure washer with wheels, guide
handle.
•
High Pressure Hose
•
Parts Box (which includes items listed below)
Spray Gun
•
Wand Extension with Hi/Lo Adjustable Nozzle.
•
Engine Oil
•
Manual Bag (which includes the Items listed
below)
•
Owner's Manual
•
Nozzle Cleaner Kit
•
=O'-Ring Kit
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on Page 5. If any parts are missing or
damaged, call the Pressure Washer Helpline at
1-800-222-3136.
TO REMOVE
PRESSURE
WASHER
FROM
CARTON
•
Remove loose parts and parts box included with
pressure washer.
•
Slice two comers at guide handle end of carton
from top to bottom so the panel can be folded
down flat.
•
Raise guide handle, secure in place and rollthe
pressure washer out the open end of the carton.
HOW TQ SET UP YOUR PRESSURE
WASHER
For the most part, your Craftsman High Pressure
Washer has been assembled at the factory. You must,
however, assemble the spray gun, and attach the high
pressure hose to the pump and spray gun.
•
Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun. Tighten by hand.
•
Remove plastic cap and connect high pressure
hose to pump. Tighten by hand.
Remove plastic
cap and attach
high pressure
hose here
Uft the handle to
upright position and
slide the locking
caps into place
•
Check carton for additional loose pads.
• " Attach nozzle extension to spray gun.
•
Place assembled spray gun on holder.