Unpacking; Assembly; Assemble Stand - Craftsman 351.217450 Operator's Manual

• Handle workpiece correctly.Protect hands from
possible injury.
• Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
• Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
• Feed work into blade or cutter against direction of
rotation.
CAUTION: Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING: Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figures 1 and 2.
Check for shipping damage. If damage has occurred, a
claim must be filed with carder. Check for complete-
ness. Immediately report missing parts to dealer.
The planer/molder comes assembled as one unit.
Additional parts which need to be fastened to
planer/molder should be located and accounted for
before assembling.
A. Handle Assembly
B. 5-0.8 x 25mm Socket Head Bolt
C. Plug
D. Roller Height Adjustment Wrench
E. Dust Chute
F. 6-1.0 x 25mm Socket Pan Head Screw
G. Roller (2)
H. Molding Gib and Spacer Set (4)
Not Shown:
Half Bag Dust Collection Set
Auxiliary Table Hardware Bag (Part No. 21012.00)
includes:
• #10-32 x 23/d ' Socket Head Bolt (2)
• #10 FlatWasher (2)
• Clamp (2)
• 1/,-20 x 11/, " Wing Screw (4)
• 1/4" Flat Washer (4)
• Table Insert (4)
Figure 1 - Unpacking Planer/Molder
The stand comes unassemb_edand packed along with
the planer/molder in the same box. Locate and identify
all parts before attempting assembly.
A. Frame, long (2)
B. Frame, short (2)
C. Brace, long (2)
D. Brace, short (2)
E. Leg, stamped 'A' (2)
F. Leg, plain (2)
Not Shown:
Stand Hardware Bag (20896.00) includes:
• 8-1.25 x 80ram Hex Head Bolt (4)
• 8mm Flat Washer (8)
• 8-1.25mm Hex Nut (4)
• S/le-18 X =/4"
Carriage Bolt (24)
• 51_e"-18 Washer Head Bolt (24)
A
E
F
Figure 2 - Unpacking Stand
WARNING: Do not attempt assembly if parts are miss-
ing. Use this manual to order replacement parts.
ASSEMBLE STAND
Refer to Figures 3 and 4, Page 4.
• Place the long and short frame pieces on the floor.
Lay out the pieces in a rectangle with the long and
short frames oppositeto each other. '
• Assemble the legs to the outside of the frames using
cardage bolts and nuts.
NOTE: Leg set that is stamped 'A' goes in diagonally
opposing corners and the plain set goes'in other two
corners. Leg 'A' must be installedwith short brace on
right and long brace on left in order for the stand to be
square and level (See Figure 4, Page 4).
• Leave nuts and bolts finger tight for now.
3