Craftsman 917.276211 Owner's Manual page 27

TO REMOVE WHEEL FOR REPAIRS
FRONT WH EEL -
1. Block up axle securely.
2, Remove axle cover, retaining ring and
washers to allow wheel removal.
3. Repair tire and reassemble,
4. Replace washers and snap retaining
ring securely in axle groove,
5_ Replace axle cover°
REAR WHEEL -
1. Block rear axle securely.
2, Remove five (5) hub bolts to allow
wheel removal.
3, Repair tire and reassembieo Replace
and tighten hub bolts securely,
NOTE: To seal tire punctures and prevent
fiat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer, Tire sealant also prevents tire dry
rot and corrosion.
Retaining Washers
Ring
_
Axle Cover
TO START ENGINE WITH AWEAK BAT-
TERY
_(_,WARNING" Lead-acid batteries
generate explosive gases. Keep sparks,
flame and smoking materials away from
batteries. Always wear eye protection
when around batteries.
If your battery is too weak to start the en-
gine, it should be recharged. (See "BAT-
TERY" in the MAINTENANCE section of
this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: Your tractor is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1. Connect one end of the RED cable
to the POSITIVE (+) terminal of each
battery(A-B), taking care not to short
against tractor chassis,
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of
fully charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground,
away from fuel tank and battery_
TO REMOVE CABLES, REVERSE
ORDER -
t, BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead Fully Charged
Battery Battery
REPLACING BATTERY
41_WARNING: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental ground-
ing,
1, Lift hood to raised position.
2. Remove terminal guard°
3, Disconnect BLACK battery cable then
RED battery cable and carefully re-
move battery from tractor,
4_ Install new battery with terminals in
same position as old battery.
5, Reinstall terminal guard.
6o First connect RED battery cable to
positive (+) battery terminal with hex
bolt and keps nut as shown, Tighten
securely,
7, Connect BLACK grounding cable to
negative (-) battery terminal with re-
maining hex bolt and keps nut, Tighten
securely
8, Close terminal access doors.
9, Close hood,
Keps
Terminal ,* Hex Bolt
Access
Door _ (Red)
o:, Cable
Guard ,gative (Black)
Cable
27