Craftsman 917.276211 Owner's Manual page 15

1, Lower mower and adjust mower to de-
sired cutting height(See "1"OADJUST
MOWER CUTTING HEIGHT" in this
section of manual).
2. Remove retainer spring and clevis pin
which secure each gauge wheel bar,
3. Lower gauge wheels to ground. Raise
gauge wheels slightly to align holes
in bracket and gauge wheel bar and
insert clevis pin° Gauge wheels should
be slightly off the ground.
4. Replace retainer spring into clevis pin,
5, Be sure all gauge wheels are in the
same setting.
IMPORTANT: Be sure to readjust gauge
wheels if you change the cutting height
of the mower deck.
Retainer
Spring
Clevis
Pin
TO ADJUST MOWER CUTTING HEIGHT
The cutting height is controlled by turning
the height adjustment knob in desired
direction.
• Turn knob clockwise (F_) to raise cut-
ting height,
o Turn knob counterclockwise (_"_)to
lower cutting height°
The cutting height range is approximately
I-1/2" to 4-1/2"o The heights are mea-
sured from the ground to the blade tip with
the engine not running. These heights
are approximate and may vary depending
upon soi! conditions, height of grass and
types of grass being mowed.
° The average lawn should be cut to
approximately 2-1/2 inches during the
cool season and to over 3 inches during
hot months, For healthier and better
looking lawns, mow often and after
moderate growth.
° For best cutting performance, grass
over 6 inches in height should be
mowed twice Make the first cut
relatively high; the second to desired
height,
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch_ Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine, You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating
or cutting off when operating your equip-
ment on rough, rolling terrain or hills.
t. Select desired height of cut,
2. Lower mower with attachment lift con-
trol.
3o Start mower blades by engaging at-
tachment clutch control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
/%
_t, CAUTION: Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the deflector
shield in place.
Attachment Lift Lever
( Oeflootor
REVERSE OPERATION SYSTEM (ROS)
Your tractor is equipped with a Reverse
Operation System (ROS). Any attempt by
the operator to travel in the reverse direc-
tion with the attachment clutch engaged
will shut off the engine unless ignition key
is placed in the ROS "ON" position_
A(_,WARNING: Backing up with the at-
tachment clutch engaged while mowing
is strongly discouraged. Turning the ROS
"ON", to allow reverse operation with the
attachment clutch engaged, should only
be done when the operator decides it is
necessary to reposition the machine with
the attachment engaged, Do not mow in
reverse unless absolutely necessary,
15