Advertisement
Your new tractor has been assembled at the factory with exception of those pads left
unassembled for shipping purposes. To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness. Review the video cassette before
you begin.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" wrench
(2) 1/2" wrench
(1) Utility knife
(1) Pliers
(1) 3/4" socket with
(1) Tire pressure
drive ratchet
gauge
When dght or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating
position (seated behind the steering
wheel).
TO REMOVETRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts boxes from shipping carton.
• Cut, from top to bottom, along lines on
all four comers of shipping carton, and
lay panels flat.
• Check for any additional loose parts or
boxes and remove.
BEFORE REMOVING TRACTOR
FROM SKID
ATI'ACH STEERING WHEEL
ASSEMBLE
EXTENSION
SHAFT AND
BOOT
• Slide extension shaft onto lower
steering shaft.
Align mounting holes in
extension and lower shafts and install
5/16 hex bolt and Iocknut.
Tighten
securely.
• Place tabs of steedng boot over tab
slots in dash and push down to secure.
INSTALL STEERING
WHEEL
• Position front wheels of the tractor so
they are pointing straight forward.
• Remove steering wheel adapter
from
steering wheel and slide adapter
onto
steering shaft extension.
• Position steering wheel so cross bars
are horizontal (left to right) and slide
inside boot and onto adapter.
• Assemble
large flat washer,
3/8 lock
washer, 3/8 hex bolt and tighten
securely.
• Snap steedng wheel insert into center
of steering wheel.
• Remove
protective materials from
tractor hood and gdll.
IMPORTANT:
Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
Insert
_,_
Lockwasher
Large Flat
_
Washer
Steering
_
Steering
Wheel
HOW TO SET UP YOUR TRACTOR
CONNECT BATTERY
Lift hood to raised position.
If this battery is put into service after
month and year indicated on label
(label located between
terminals)
charge battery for minimum of one hour
at 6-10 amps. (See 'BATTERY"
in
MAINTENANCE
section of this manual
for charging instructions).
7
Advertisement
