Advertisement
Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4" truss head bolts and 5/16"
nylock nuts as shown in figure 4. Heads of bolts go on
the inside of cart. Tighten.
5/16" x 3/4"
TRUSS HEAD BOLT
WHEEL
SUPPORT
\
5/16"
NYLOCK
_ _
NUT
\
FIGURE 4
To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down, with the wheel support facing up, as shown in
figure 5.
Align the latch stand bracket so that the tab is at the
rear. Fasten the bracket to the rear set of holes at the
front of the cart using two 1/4" x 5/8" hex bolts, 1/4"
flat washers and 1/4" nylock nuts. Use the 1/4" flat
washers as shims between the bracket and the cart
bed. Make finger tight. See figure 5.
LATCH STAND
BRACKET
1/4" NYLOCK NUT
(Tab at rear)
/
1/4" FLAT
\
1/4" × 5/8"
HEX BOLT
FIGURE 5
•
Position the rear tongue on the wheel support and the
latch stand bracket. Assemble the axle through the
wheel support and the tongue. See figure 6.
iMPORTANT:
Make sure the tongue is securely locked
to the latch stand bracket by the latch lock lever.
AXLE
TONGUE
FIGURE 6
Assemble a spacer tube, a 1" fiat washer, a wheel
(valve stem facing out), and another 1" flat washer
onto the axle as shown in figure 7. Secure the wheel
with a cotter pin, spreading the ends so that a hub
cap can fit over the pin. Assemble the hub cap by
pressing it onto the flat washer. Repeat on other end
of axle.
Pump grease into grease fittings on wheels until
grease is forced out through ends of hubs.
SPACER TUBE
WHEEL
\
1" FLAT
\
WASHER
\
T
HUB CAP
COTTER PIN
1" FLAT
WASHER
FIGURE 7
Advertisement
