Table of Contents
Advertisement
Available languages
Available languages
g.
Move throttle lever to "Fast" position, shown here
as a rabbit.
Fast
Stop
f
Throttle
Lever in
STOP
position
NOTE: For a warm engine, be sure the throttle lever is
in the "Fast" position.
To start the engine for the very first time:
10. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
11. Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
10. Make sure throttle lever is in "Fast" position
(indicated on the engine as a rabbit).
11. Press primer bulb firmly 3 times, waiting
2 seconds between each push. For a warm
engine, DO NOT press primer bulb.
12. Grasp starter grip handle and pull slowly until you
feel some resistance. Then pull rapidly to start
engine.
WARNING
]
When
starting
engine,
pull cord
slowly
until resistance
is
felt and then
pull rapidly
to avoid kickback.
If engine
starts
and fails to continue
to run or if increased
resistance
is felt during
starting
pul! attempts,
squeeze
trigger
on spray
gun.
13. Return starter grip handle slowly. DO NOT let rope
"snap back" against starter.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
a, cAuTmo.
]
• Always
use handle
to lift equipment.
• NEVER
pull on hoses
to move equipment.
WARNING
DO NOT touch
hot surfaces.
Allow
equipment
to coo! before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on al! sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing.
In the State of California
a spark arrester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other states may have similar
laws. Federal laws apply on
federal
lands. If you equip the muffler
with a spark attester,
it must be maintained
in effective
working
order.
How to Stop Your Pressure
Washer
1.
Let engine idle for two minutes.
2.
Move throttle lever on engine to "Stop" position.
3.
Squeeze trigger
on spray gun to relieve
trapped
pressure
in hose to avoid injury.
NOTE: A small amount of water will squirt out when
)ressure is released.
WANNING
Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
Squeeze
trigger
on spray
gun to relieve
trapped
pressure,
every time you stop engine.
Engage
trigger
lock on spray
gun.
4.
Engage trigger lock on spray gun when not in use.
How To Use the Adjustable
Nozzme
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
CAUTION
NEVER adjust spray pattern when spraying.
NEVER put hands in front of nozzle to adjust spray pattern,
On the end of your spray
gun is a nozzle
handle that
can adjust
the spray
pressure
and the spray
pattern.
Advertisement
Table of Contents
