OPERATION
TIPS FOR IMPROVED
BAGGING
OPERATION:
Follow the mower operation instructions in your tractor
owner's manual.
When operating your grass catcher on a lawn where grass
and leaf bagging equipment has not been used, you are
picking up thatch and debris that has accumulated for long
periods of time. The amount collected and the total time of
operation may be greater than you will experience with
regular use of your grass catcher.
Always run throttle at full speed when bagging.
Select a gear low enough to give good mower cutting
performance, good quality cut and good bagging per-
formance.
NOTE: It may be necessary to ovedap width of cut to suit
your conditions.
If grass is extremely tall, it should be mowed twice. The
first time relatively high, the second time to desired
height.
Use left hand side of mower for trimming.
Plastic trash bags can be inserted inside grass catcher
containers for ease of debris disposal. To remove the
plastic trash bags when full:
a.
Disengage blades, shift into neutral, engage the
parking brake and stop the engine.
b.
Raise seat. Unlatch and raise cover.
c.
Remove one container at a time by grasping con-
tainer handles and pulling toward the rear, off of the
tube rails.
d.
With the container resting on the ground, close and
secure the top of the plastic lawn bag.
e.
Tip the container on its side and slide the filled bag
from the container.
f.
Install a new plastic lawn bag with the edges of the
bag draped over upper lip of the Container (for
replacement
bags
refer
to REPLACEMENT
PARTS).
g.
Repeat for other container.
h.
Reinstall containers making sure right container
overlaps left container at center support.
j.
Close cover and secure latch over center support
tube.
Avoid cutting wet grass or in the morning while the dew
is still heavy. Grass clippings collected under these
conditions tend to be sticky and adhere to the walls of
the flow path causing clogging.
Your bagger is equipped with a full bagger indicator. As
the bags become full, the movement of the wheel will
slow down and/or stop, indicating that the bags are full
or the chutes have become clogged. Care should be
taken not to damage the parts and that the wheel spins
freely at the beginning of each use.
If the grass catcher fails to pick up cut grass or leaves,
it is an indication that clogging has occurred in the
system or that the grass catcher containers are full.
a.
Disengage blades, shift into neutral, engage the
parking brake and stop the engine.
- Raise seat. Unlatch and raise cover.
b.
C,
- Slide out containers and dispose of clippings.
- Replace containers, close cover, and latch.
Unlatch chutes and check for clogging
- Remove all debris in chutes.
- Reassemble and latch chutes
Check to insure full bagger indicator has not be-
come clogged.
- The air passage hole must be clear of debris.
Gently insert a small twig or wire into passage-
way to clear.
CAUTION
•
Do not operate mower with grass catcher
partially installed.
•
Disengage blades and stop engine before
leaving tractor seat to empty containers,
unclogging chutes, etc.
•
Close cover before starting.
•
Disengage mowerwhen crossing driveways
or gravel surfaces and other areas where
thrown objects could be a hazard.
•
Do not attempt to vacuum up cans or other
potentially hazardous projectiles.
9