Advertisement
ASSEMBLY
MOUNTING
TO TRACTOR
(See Fig. 3)
Use Hardware
- - GROUP
"C"
NOTE: For ease of assembly, you may wish to obtain the
assistance
of another person for mounting assembly to
tractor.
•
Raise seat on tractor to allow assembly to be mounted.
•
With cover closed, lift assembly and place support post
inside mounting bracket. Allow assembly to rest on
lanced tabs of mounting bracket.
•
Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with retainer
spring.
•
Unlatch and open cover•
COVER
ASSEMBLY
RETAINER
SPRING
:/
SUPPORT
LANCED
TABS
MOUNTING
BRACKET
Fig. 3
CONTAINER
ASSEMBLY
(See Fig. 4)
No hardware
required
•
Place bottom half inside of top half, as shown,
•
Place one foot inside bottom half and lifttop half to meet
bottom half,
•
Press halves tightly together while lifting top to lock into
place as shown.
IMPORTANT: BEFORE LOCKINGTHETABS, HOOKED EDGES
ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS
SHOWN IN INSET,
•
Repeat for second container.
CONTAINER
_/BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS
TOGETHER
TO FORM
SEAL
WHILE
LIFTING
TOP
HALF
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves.
If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
Fig. 4
7
Advertisement
