Table of Contents
Advertisement
Fig. 14
Fig. 15
Fig. 16
induction Cooktop Display Messages
LED MESSAGESOR LIGHT INDICATORS DISPLAYED
BY COOKING ZONECONTROLS (CONT'D}
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
POWER LEVEL SETTINGS - The Cooking Zones have five separate Power Level LEDs.
Once active, the Cooking Zones will provide 10 Power Levels to choose from. These include 7
2, 3, _, 5, 6 (fig. 14), 7, 8, 9. The highest setting of Por "Power Boost" provides 125%
power level for 10 minutes (See Fig. 13). Each key pad touch (or just holding down the Power
Level key pad) will scroll through all the available power levels for any Cooking Zone quickly
(See pages 14-17 for complete instructions).
RESIDUAL HEAT- Once any Cooking Zone has been used for cooking and turned OFF, and
if the cooktop surface temperature on any of the Cooking Zones is still too HOT, H (See Fig.
15) will appear in the LED display for the affected Cooking Zone. The H will continue to
display if the temperature is still too HOT.
KEEP WARM - Use the WARM (or LOW) key pad to activate the Warm setting for any of the
Cooking Zones. The ON/OFF key pad for the desired Cooking Zone must be activated first
then touch the WARM key pad located in the Cooktop Main Control area once to set. L
(LOW) should appear in the corresponding Cooking Zone LED (See Fig. 16 & page 16 for
complete information).
PAN DETECTION -All five Cooking Zones will provide a Pan Detection message. Ifa Cooking
Zone is turned ON and no pan is detected for the Cooking Zone, the pan has been moved or
if the pan is not centered correctly or if the pan is not made of magnetic material, F (See Fig.
17) will appear in the affected Cooking Zone LED display.
Advertisement
Table of Contents
