Advertisement
SERVICE A
ADJUSTMENTS
ENGENE
TO ADJUST
THROTTLE
CONTROL
CABLE
(See Fig, 36)
T!le throttle control has been preset at the factory and
adjustment should not be necessary_ Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
o
With engine not running, move throttle control lever to
fast position,,
•
Check that speed control lever is against stop screw. If
it is not, loosen casing clamp screw and pull throttle
cable until lever is against screw Tighten clamp screw
securely,
IDLE FUEL
ADJUSTING
NEEDLE
.... T O ADJUST
CHOKE
CONTROL
............
_i (See Figs,"36
arid37)
/
THROTTLE
CONTROL
CABLE
STOP
SCREW
CLAMP
SCREW
IDLE SPEED
ADJUSTING
SCREW
The choke control has been preset at the factory and
adjustment should not be necessary,, check adjustment as
described below before loosening cable,, If adjustment is
necessary, proceed as follows:
o
With engine not running, move choke control (located
on dash panel) to full choke position°
o
Remove air cleaner cover, filter and cartridge plate to
expose carburetor choke (See "AIR FILTER" in the
Customer Responsibilities
section of this manual),.
•
Choke should be closed
If it is not, loosen casing
clamp screw and move choke cable until choke is
completely closed,, Tighten casing clamp screw se-
curely.
o
Reassemble air cleaner.
CHOKE
CONTROL
CABLE
CLOSED FOR
FULL CHOKE
FIG. 37
FIG. 36
27
Advertisement
