Advertisement
HOLD
DOWN
FOOT
LOCK
KNOB
Allows you to raise or lower the hold down footfoiade
guard and secure it at desired heights.
SAWDUST
BLOWER
Keeps the line of cut on workplace clean for more
accurate scroll cuts.
SAW
TABLE
Your scroll saw has an aluminum saw table that
provides a working surface to support your workplace.
TABLE
LOCK
KNOB
Allows you to tilt the table and lock it at the desired
angle up to 47 degrees.
BEVEL
SCALE
The bevel scale and indicator are located on the front
of the saw for easy viewing. They show the angle of
the table.
ZERO
DEGREE
STOP
FOR TABLE
Allows easy return and fine adjustment of the zero
aegree relationship between the table and the blade.
Your Craftsman 24 in. scroll saw was fully assembled
at the factory. Before operating this tool, it is Important
to check all alignments and settings. Normal handling
during shipment may have changed settings.
_k, WARNING: To avoid sedous personal injury
from unexpected tool movement, always
securely mount scroll saw to a workbench.
MOUNTING
SCROLL
SAW
TO
WORKBENCH
See Fi ure 5.
If the scroll saw is to be used in a permanent applica-
tion, we recommend that you secure It in a permanent
location such as a workbench. When mounting the
saw to a workbench, holes should be drilled through
the supporting surface of the workbench using dimen-
sions illustrated.
Each hole in the base of the saw should be
bolted securely using 3/8 in. diameter machine
bolts, lock washers, and hex nuts (not included).
Bolt length should be 1-1/4 in. plus the thickness
of the bench top.
•
Locate and mark the holes where scroll saw is to
be mounted,
•
Drill (3) 7/16 in. diameter holes through work-
bench.
•
Place scroll saw on workbench aligning holes in
the base with holes drilled in the workbench.
•
Insert all three 3/8 in. bolts and tighten securely
with lock washers end hex nuts.
Note: All bolts should be inserted from the top. Install
the lock washers and hex nuts from the underside of
the bench.
Supporting surface where scroll saw is mounted
should be examined carefully after mounting to insure
that no movement dudng use can result. If any tipping
or walking is noted, secure workbench or supporting
surface before beginning cutting operations.
V
lS"
I
_ _Of7/16"
DIA. HOLE
-O-
,j
10.,6cm
I
21 cm
10.5cm I
i
I
i9.2m
I
g.2cm
73.1cm
36"
Fig. 5
11
Advertisement
