Advertisement
_i,
WARNING: When servicing, use only identical
Craftsman replacement parts. Use of any other
part may create a hazard or cause product
damage.
&
WARNING: To prevent accidental starting that
could cause possible serious personal injury,
turn off and unplug the saw before maintaining or
lubricating your scroll saw.
GENERAL
MAINTENANCE
Keep your Scroll Saw clean.
After cleaning the table top initially, apply a thin
coat of automobile type (paste) wax to the table
top so the wood slides easily while cutting.
ARM
BEARINGS
See Fi ure 17.
Lubricate the arm bearings after every 50 hours of
use or whenever there is a squeak coming from the
bearings.
•
Carefully place the saw on its side as shown in
Fi ure17.
Squirt a few drops of SAE20 oil in the small hole
in the middle of the slot. Lubricate both upper
arm and lower arm bearings. Let oil soak in
overnight, remaining in this position.
_i,
WARNING:
If the power cord is wom, cut, or
damaged in any way, have it replaced
Immediately by a qualified service technician at a
Sears store to avoid risk of personal injury.
SLOT
ARMBEARING
Fig. 17
19
Advertisement
