Mounting Bracket - Dyson Airblade Owner's Manual

Positioning Mounting Bracket
/_ WARNING: Before
beginning any installation
work you must confirm the
following:
Make sure that the eledricai
supply has been disconnected or
switched off before attempting
installation to avoid the risk of
electrical shock or electrocution.
Ensure no pipe work (gas, water,
air) or electrical cables, wires or
ductwork are located directly
behind the drilling area.
/t,,
Select a location that will allow
accessibility to the Airblade
TM
and proper clearance from
surroundings and floor. Make
sure that the unit is installed in
compliance with all building
codes and/or regulations.
Position the mounting template
provided on the wall where the
Airblade
TM
hand dryer is to be
installed.
Bracket mounting height: ....
39" adult male height
36" adult female height
32" chlid/wheeJchalr user helghl
Electrical supply connection
Floor
Recommended heights are shown
in Fig1, but may need to be
adjusted for each individual
installation.
Mark the 6 mounting holes as
highlighted in Fig 1
Verify marks are level and in the
correct locations.
Drill holes where marked.
mm.
k
t
2"
29.75"adult male hdght
26.75"adult female height
22 75"chfld/wheelchdr user height
C
There are two electrical entrance
locations available to ease with
the installation of the Airblade
TM
hand dryer. Mark only one of
the electrical supply locations
illustrated in Fig1 and drill the hole
large enough to accommodate
the incoming flexible metal conduit
and supply cable.
Ensure that marks are level and
in the correct location as illustrated
in Fig 2.
Securely fasten the mounting
bracket to the wall.
Recommended minimum anchor
size of 0.25"
I I
...... .... .......
t t