Desa Comfort Glow CGP20TLB Owner's Operation And Installation Manual page 8

BLUE FLAME PROPANE/LP HEATER
INSTALLATION
Continued
THERMOSTAT SENSING
BULB
The thermostat sensing bulb has been placed
insidetheheater forprotection duringshipping.
Locating Thermostat Sensing
Bulb
1. Remove front panel of heater (see Fig-
ure 7).
2. Locate thermostat sensing bulb just
under burner assembly.
IMPORTANT: Attach thermostat sensing
bulb to back of heater for proper operation.
Attaching Thermostat Sensing
Bulb
1. Remove thermostat sensing bulb from
holders inside heater. Route through
slot opening in bottom of heater.
2. Place clamp on thermostat sensing bulb
as shown in Figure 5. Clamp is pro-
vided in hardware package.
3. Snap clamp into upper mounting hole
as shown in Figure 5. Mounting hole is
located on lower left edge on back of
heater. Make sure the thermostat sens-
ing bulb is pointing up.
Thermostat
Bulb
Figure 5- Attaching ThermostatSensing
Bulb
INSTALLING HEATER TO
WALL
Mounting Bracket
The mounting bracket is local_l on back
panel of heater. R has been taped them for
shipping. Remove mounting bracket from
back panel.
Figure 6 - Bracket Location
Removing Front Panel Of Heater
I. Remove two screws near bottom cor-
ners of front panel.
2. Lift straight up on grill guard unlil it stops.
Grill guard wig slide up about 1/4".
3. Pull bottom of front panel forward, then
downward.
4. Remove cardboard packing from grill
and glass.
Attachingto wall stud: This method
provides the strongest hold. Insertmounting
screws through mounting bracket and into
wall studs.
Attaching to wall anchor: This method
allows you to attach mounting bracket to
hollow walls (wall areas between studs) or
to solid walls (concrete or masonry).
Decide which method better suits your needs;
Either method will provide a secure hold for
the mounting bracket.
Marking Screw Locations
1. Tape mounting bracketto wall where
heater will be located. Make sure
mounting bracket is level.
AWARNING: Maintain minimum
clearances shown in Figure 8. If
you can, provide greater clear-
ancea from floor and joining wall.
2. Mark screw locations on wall (see Fig-
are 8).
Note: Only mark last hole on each end
of mounting bracket. Insert mounting
screws through these holes only.
3. Remove tape and mounting bracket
fromwal,:
Jl \
/I
/ Only Insert Mounting la _'4"
Screws Through Last I
Hole On EaCh End U n.
Figure 7- Removing Front Panel Of Heater
30,000 Btu/Hr Model
Methods For Attaching
Mounting
Bracket To Wall
Only use last hole on each end of mounting
bracket to attach bracket to wall. These two
holes are 16 inches apart from their centers.
Attach mounting bracket to wall in one of
two ways.
1. Attaching to wall stud
2. Attaching to wall anchor
Only Insert Mou g 18 3/4"
SCllWS Throu h Last
20,000 Btu/Hr Models
Figure 8 - Mounting Bracket Clearances
8 to4332