Desa Comfort Glow CGP10TLA Owner's Operation And Installation Manual page 8

VENT-FREE PROPANE/LP GAS HEATER
INSTALLATION
Continued
Installing Two Mounting Screws
Note: Wall anchors and mounting screws
arein hardwarepackage. The hardwarepack-
age is provided with heater.
Attaching To Wall Stud Method
For attaching mounting screw to wall stud
1. Drill hole atmarked location using 9/64"
drill bit.
2. Insert mounting screw into wall stud.
3. Tighten screw until 1/16" space (thick-
ness of penny) is between screwhead
and wall.
Attaching To Wall Anchor
Method
Follow instructions below to attach mount-
ing screws to hollow walls (wall areas be-
tween studs) or solid walls (concrete or
masonry).
1. Drill holes at marked locations using
5/16" drill bit. For solid walls (concrete
or masonry), drill at least 1 _/4"deep.
2. Fold wall anchor (see Figure 6).
3. Insert wall anchor (wings first) into
hole. Tap anchor flush to wall.
4. For thin walls (1/2" or less), insert red
key into wall anchor. Push red key to
"pop" open anchor wings (see Figure
7). IMPORTANT:Do not hammer key!
For thick walls (over 1/2"thick) or solid
walls, do not pop open wings.
5. Tighten two screws until 1/16" space
(thickness of penny) is between
screwheads and wall (see Figure 8).
Figure 6. Folding Anchor
Wall
(thick wall
shown)
1/16"
-- Solid Wall
Figure 8 - Tightening Anchors
Placing Heater On Mounting
Screws
1. Locate two keyhole slots on back panel
of heater (see Figure 9).
2. Place large openings of slots over
screwheads. Slide heater down until
screws are in small portion of slots.
Figure 9 - Location Of Keyhole Slots On
Back Panel Of Heater
Removing Front Panel Of Heater
1. Remove two screws near bottom cor-
ners of front panel.
2. Lift straight up on grill guard until it
stops. Grill guard will slide up about
1/4".
3. Pull bottom of front panel forward,then
down.
Installing Bottom Mounting
Screw
1. Locate bottom mounting hole. This
hole is near bottom on back panel of
heater (see Figure I1).
2, Mark screw location on wall.
3. Remove heater from wall.
4.
If installing bottom mounting screw
into hollow or solid wall, install wall
anchor. Follow steps 1 through 5 un-
der Attaching To Wall Anchor Method,
column 1.
5.
6,
7.
If installing bottom mounting screw
into wall stud, drill hole at marked lo-
cation using 9/64" drill bit.
Replace beater on wall.
Insert bottom anchor screw through
back panel into bottom anchor or
drilled hole (see Figure 11).
Tighten screw until heater is firmly
secured to wall. Do not over tighten.
Note: Do not replace front panel at this
time. Replace front panel after making
gas connections and checking for leaks
(see pages 9 and I0 ).
/
Figure 11 - Installing Bottom Mounting
Screw
Rgure 7. Popping Open Anchor Wings Figure 10 - Removing Front Panel Of
For Thin Walls Heater