Advertisement
/
/
/
INNER NUT
OUTER NUT
/
CLUTCH
CABLE
ADJUSTMENT
Remove four screws from Rear Drive Cover. Lay aside
cover and screws.
Place Clutch Lever in "DISENGAGED"
position
The Cable should be under slight tension but should
not pull the Clutch Lever more than 1/8" away from the
Switch Body.
NOTE: If the Plunger extends more than 1/8" out from
the switch body, the cable tension is too tight and the
Engine will not start.
TO INCREASE
CABLE
TENSION
Place Blade Clutch Lever in the "DISENGAGED"
position.
Loosen the inner nut on the Clutch Cable.
Tighten the outer nut on the Clutch Cable.
SWITCH
BODY
TO DECREASE
CABLE
TENSION
Place Blade Clutch Lever in the "DISENGAGED"
position.
•
Loosen the outer nut on the Clutch Cable.
•
Tighten the inner nut on the Clutch Cable.
•
Repeat the above procedure until you have the correct
tension.
PLUNGER
CLUTCH LEVER
REAR DRIVE ''''''''''_"
COVER
FOUR
SCREWS
ENGINE
PULLEY
BLADE
PULLEY
©
©
©
IDLER
PULLEY
CLUTCH LEVER
FIG. 2
9
Advertisement
